Is ADXL345 3-Axis Accelerometer Compatible with Arduino Ecosystem?
Hardware Safety & Electrical Verification
Electrical parameters & logic voltage safety limits before powering ICs
## Compatibility Overview
Ultra-low power 3-axis accelerometer with 13-bit measurement resolution up to +/-16g for motion activity tracking.
Interactive Pinout & Wiring Diagram
Hover over any pin to view voltage limits and pull-up specifications
## Technical Specification Matrix
| Feature / Attribute | Specification / Status |
|---|---|
| Hardware Protocol | I2C / SPI / 3.3V |
| Bridge Required | NO |
| Border Router Needed | None |
| Hardware Capabilities & Peripherals | Acceleration X (g) Y (g) Z (g) Tap Detection Note: Exposing entities to Home Assistant requires corresponding YAML component config. |
| Pairing Complexity | Intermediate |
| Factory Reset Instruction | Press BOOT button while resetting. |
## Step-by-Step Pairing Guide
Factory Reset Device
Press BOOT button while resetting.
Initialize Pairing Mode on Arduino Ecosystem
Open Arduino Ecosystem administration console, navigate to Integrations / Add Device, and start pairing scanner.
Confirm Entity Binding & State Verification
Verify that primary entities (Acceleration X (g), Y (g), Z (g), Tap Detection) report live state changes inside Arduino Ecosystem.
Production Code Generator & Preset Toolkit
Pre-configured pinouts & drivers for ADXL345 3-Axis Accelerometer
Report a Pinout Error or Submit Tested Code Snippets
Found a pin mapping quirk or built a custom ESPHome YAML driver for ADXL345 3-Axis Accelerometer? Help us keep this matrix 100% accurate.