Is BME680 Environmental & Gas Sensor Compatible with Home Assistant (ESPHome)?
Hardware Safety & Verification Specs
Electrical parameters & logic voltage safety limits before powering ICs
## Compatibility Overview
The ESP32-C3 SuperMini paired with Bosch BME680 provides accurate indoor air quality pressure and ambient humidity readings directly to Home Assistant.
Interactive Pinout & Wiring Diagram
Hover over any pin to view voltage limits and pull-up specifications
## Technical Specification Matrix
| Feature / Attribute | Specification / Status |
|---|---|
| Hardware Protocol | I2C Bus / 3.3V |
| Bridge Required | NO |
| Border Router Needed | None |
| Exposed Entities | Temperature Relative Humidity Barometric Pressure IAQ Gas Index |
| Pairing Complexity | Intermediate |
| Factory Reset Instruction | Short GPIO9 to GND during power-on to trigger bootloader mode. |
## Step-by-Step Pairing Guide
Factory Reset Device
Short GPIO9 to GND during power-on to trigger bootloader mode.
Initialize Pairing Mode on Home Assistant (ESPHome)
Open Home Assistant (ESPHome) administration console, navigate to Integrations / Add Device, and start pairing scanner.
Confirm Entity Binding & State Verification
Verify that primary entities (Temperature, Relative Humidity, Barometric Pressure, IAQ Gas Index) report live state changes inside Home Assistant (ESPHome).
Production Code Generator & Preset Toolkit
Pre-configured pinouts & drivers for BME680 Environmental & Gas Sensor
Report a Pinout Error or Submit Tested Code Snippets
Found a pin mapping quirk or built a custom ESPHome YAML driver for BME680 Environmental & Gas Sensor? Help us keep this matrix 100% accurate.