Is BME280 Temp Humidity Barometer Compatible with Home Assistant (MicroPython)?
Hardware Safety & Verification Specs
Electrical parameters & logic voltage safety limits before powering ICs
## Compatibility Overview
High-precision environmental monitoring pairing using Pico W and Bosch BME280 sensor over MicroPython MQTT API.
Interactive Pinout & Wiring Diagram
Hover over any pin to view voltage limits and pull-up specifications
## Technical Specification Matrix
| Feature / Attribute | Specification / Status |
|---|---|
| Hardware Protocol | I2C Bus / 3.3V |
| Bridge Required | NO |
| Border Router Needed | None |
| Exposed Entities | Temperature Sensor Relative Humidity Pressure (hPa) |
| Pairing Complexity | Plug-and-Play |
| Factory Reset Instruction | Press BOOTSEL button while inserting USB cable. |
## Step-by-Step Pairing Guide
Factory Reset Device
Press BOOTSEL button while inserting USB cable.
Initialize Pairing Mode on Home Assistant (MicroPython)
Open Home Assistant (MicroPython) administration console, navigate to Integrations / Add Device, and start pairing scanner.
Confirm Entity Binding & State Verification
Verify that primary entities (Temperature Sensor, Relative Humidity, Pressure (hPa)) report live state changes inside Home Assistant (MicroPython).
Production Code Generator & Preset Toolkit
Pre-configured pinouts & drivers for BME280 Temp Humidity Barometer
Report a Pinout Error or Submit Tested Code Snippets
Found a pin mapping quirk or built a custom ESPHome YAML driver for BME280 Temp Humidity Barometer? Help us keep this matrix 100% accurate.