Is Presence Sensor FP2 Compatible with Home Assistant?
Hardware Safety & Verification Specs
Electrical parameters & logic voltage safety limits before powering ICs
## Compatibility Overview
The Aqara FP2 uses mmWave radar technology for precise presence detection in Home Assistant via the local API without cloud reliance.
Interactive Pinout & Wiring Diagram
Hover over any pin to view voltage limits and pull-up specifications
## Technical Specification Matrix
| Feature / Attribute | Specification / Status |
|---|---|
| Hardware Protocol | Wi-Fi (Local API) |
| Bridge Required | NO |
| Border Router Needed | None |
| Exposed Entities | Binary Sensor (Presence) Light Sensor (Lux) Zone Occupancy |
| Pairing Complexity | Intermediate |
| Factory Reset Instruction | Press and hold the reset button on the back for 10 seconds until the yellow LED flashes rapidly. |
## Step-by-Step Pairing Guide
Factory Reset Device
Press and hold the reset button on the back for 10 seconds until the yellow LED flashes rapidly.
Initialize Pairing Mode on Home Assistant
Open Home Assistant administration console, navigate to Integrations / Add Device, and start pairing scanner.
Confirm Entity Binding & State Verification
Verify that primary entities (Binary Sensor (Presence), Light Sensor (Lux), Zone Occupancy) report live state changes inside Home Assistant.
Production Code Generator & Preset Toolkit
Pre-configured pinouts & drivers for Presence Sensor FP2
Report a Pinout Error or Submit Tested Code Snippets
Found a pin mapping quirk or built a custom ESPHome YAML driver for Presence Sensor FP2? Help us keep this matrix 100% accurate.