Is Zooz Z-Wave Plus Scene Controller (ZEN32) Compatible with Home Assistant (Z-Wave JS)?
Hardware Safety & Electrical Verification
Electrical parameters & logic voltage safety limits before powering ICs
## Compatibility Overview
5-button Z-Wave scene controller switch featuring 1 relay load channel and 4 customizable RGB LED scene control buttons.
Interactive Pinout & Wiring Diagram
Hover over any pin to view voltage limits and pull-up specifications
## Technical Specification Matrix
| Feature / Attribute | Specification / Status |
|---|---|
| Hardware Protocol | Z-Wave Plus v2 |
| Bridge Required | NO |
| Border Router Needed | Z-Wave Controller 800 Series |
| Hardware Capabilities & Peripherals | Relay Load Switch 4x Scene Buttons Multi-Tap Scene Events Note: Exposing entities to Home Assistant requires corresponding YAML component config. |
| Pairing Complexity | Advanced |
| Factory Reset Instruction | Tap top paddle 3 times quickly hold on 3rd tap for 15 seconds until LED turns red. |
## Step-by-Step Pairing Guide
Factory Reset Device
Tap top paddle 3 times quickly hold on 3rd tap for 15 seconds until LED turns red.
Initialize Pairing Mode on Home Assistant (Z-Wave JS)
Open Home Assistant (Z-Wave JS) administration console, navigate to Integrations / Add Device, and start pairing scanner.
Confirm Entity Binding & State Verification
Verify that primary entities (Relay Load Switch, 4x Scene Buttons, Multi-Tap Scene Events) report live state changes inside Home Assistant (Z-Wave JS).
Production Code Generator & Preset Toolkit
Pre-configured pinouts & drivers for Zooz Z-Wave Plus Scene Controller (ZEN32)
Report a Pinout Error or Submit Tested Code Snippets
Found a pin mapping quirk or built a custom ESPHome YAML driver for Zooz Z-Wave Plus Scene Controller (ZEN32)? Help us keep this matrix 100% accurate.