Is HX711 Load Cell Scale (5kg Bar) Compatible with Home Assistant (ESPHome)?
Hardware Safety & Electrical Verification
Electrical parameters & logic voltage safety limits before powering ICs
## Compatibility Overview
24-bit ADC module paired with 5kg aluminium load cell bar for smart kitchen scale and inventory level tracking.
Interactive Pinout & Wiring Diagram
Hover over any pin to view voltage limits and pull-up specifications
## Technical Specification Matrix
| Feature / Attribute | Specification / Status |
|---|---|
| Hardware Protocol | Digital Serial / 3.3V |
| Bridge Required | NO |
| Border Router Needed | None |
| Exposed Entities | Weight Mass (grams) Tare Zero Offset Scale Calibration |
| Pairing Complexity | Intermediate |
| Factory Reset Instruction | Hold BOOT button for 3s. |
## Step-by-Step Pairing Guide
Factory Reset Device
Hold BOOT button for 3s.
Initialize Pairing Mode on Home Assistant (ESPHome)
Open Home Assistant (ESPHome) administration console, navigate to Integrations / Add Device, and start pairing scanner.
Confirm Entity Binding & State Verification
Verify that primary entities (Weight Mass (grams), Tare Zero Offset, Scale Calibration) report live state changes inside Home Assistant (ESPHome).
Production Code Generator & Preset Toolkit
Pre-configured pinouts & drivers for HX711 Load Cell Scale (5kg Bar)
Report a Pinout Error or Submit Tested Code Snippets
Found a pin mapping quirk or built a custom ESPHome YAML driver for HX711 Load Cell Scale (5kg Bar)? Help us keep this matrix 100% accurate.