Is Aqara Water Leak Sensor T1 Compatible with Home Assistant (ZHA / Z2M)?
Compatibility Overview
Zigbee water leak detector with stainless steel sensing probes for basement and appliance flood alerts.
Technical Specification Matrix
| Feature / Attribute | Specification / Status |
|---|---|
| Hardware Protocol | Zigbee 3.0 |
| Bridge Required | NO |
| Border Router Needed | Standard Zigbee Coordinator |
| Hardware Capabilities & Peripherals | Water Leak Moisture State Battery Level (%) Tamper Alarm Discovered by the integration at pairing time. Which of these appear depends on your integration and its version. |
| Pairing Complexity | Plug-and-Play |
| Factory Reset Instruction | Press and hold reset button on top cover for 5 seconds until LED blinks 3 times. |
Step-by-Step Pairing Guide
Factory Reset Device
Press and hold reset button on top cover for 5 seconds until LED blinks 3 times.
Initialize Pairing Mode on Home Assistant (ZHA / Z2M)
Open Home Assistant (ZHA / Z2M) administration console, navigate to Integrations / Add Device, and start pairing scanner.
Confirm Entity Binding & State Verification
Verify that primary entities (Water Leak Moisture State, Battery Level (%), Tamper Alarm) report live state changes inside Home Assistant (ZHA / Z2M).
Report an Error or Share What You Found in Practice
Does the reset sequence not work, an entity not appear, or the compatibility verdict not match what you see with Aqara Water Leak Sensor T1? Report a correction to our index.