Is Outdoor Motion & Lux Sensor Compatible with Home Assistant (ZHA)?
Hardware Safety & Verification Specs
Electrical parameters & logic voltage safety limits before powering ICs
## Compatibility Overview
The Philips Hue Outdoor Motion Sensor is natively supported in Home Assistant through direct Zigbee 3.0 pairing via ZHA or Zigbee2MQTT without needing a Philips Hue Bridge. It exposes motion lux and temperature sensors locally.
Interactive Pinout & Wiring Diagram
Hover over any pin to view voltage limits and pull-up specifications
## Technical Specification Matrix
| Feature / Attribute | Specification / Status |
|---|---|
| Hardware Protocol | Zigbee 3.0 |
| Bridge Required | NO |
| Border Router Needed | None (Standard Zigbee Coordinator) |
| Exposed Entities | Motion Binary Sensor Illuminance Lux Temperature Sensor Battery Level |
| Pairing Complexity | Intermediate |
| Factory Reset Instruction | Hold setup button on rear for 10 seconds until LED flashes orange then red. |
## Step-by-Step Pairing Guide
Factory Reset Device
Hold setup button on rear for 10 seconds until LED flashes orange then red.
Initialize Pairing Mode on Home Assistant (ZHA)
Open Home Assistant (ZHA) administration console, navigate to Integrations / Add Device, and start pairing scanner.
Confirm Entity Binding & State Verification
Verify that primary entities (Motion Binary Sensor, Illuminance Lux, Temperature Sensor, Battery Level) report live state changes inside Home Assistant (ZHA).
Production Code Generator & Preset Toolkit
Pre-configured pinouts & drivers for Outdoor Motion & Lux Sensor
Report a Pinout Error or Submit Tested Code Snippets
Found a pin mapping quirk or built a custom ESPHome YAML driver for Outdoor Motion & Lux Sensor? Help us keep this matrix 100% accurate.