Is Video Doorbell WiFi Compatible with Home Assistant?
Hardware Safety & Verification Specs
Electrical parameters & logic voltage safety limits before powering ICs
## Compatibility Overview
High-quality video doorbell with local RTSP and ONVIF support for Home Assistant.
Interactive Pinout & Wiring Diagram
Hover over any pin to view voltage limits and pull-up specifications
## Technical Specification Matrix
| Feature / Attribute | Specification / Status |
|---|---|
| Hardware Protocol | Wi-Fi (Local ONVIF/RTSP) |
| Bridge Required | NO |
| Border Router Needed | None |
| Exposed Entities | Camera (RTSP Stream) Binary Sensor (Doorbell Button) Motion Sensor |
| Pairing Complexity | Intermediate |
| Factory Reset Instruction | Use the reset needle to press and hold the reset hole on the back for 10 seconds until chime sounds. |
## Step-by-Step Pairing Guide
Factory Reset Device
Use the reset needle to press and hold the reset hole on the back for 10 seconds until chime sounds.
Initialize Pairing Mode on Home Assistant
Open Home Assistant administration console, navigate to Integrations / Add Device, and start pairing scanner.
Confirm Entity Binding & State Verification
Verify that primary entities (Camera (RTSP Stream), Binary Sensor (Doorbell Button), Motion Sensor) report live state changes inside Home Assistant.
Production Code Generator & Preset Toolkit
Pre-configured pinouts & drivers for Video Doorbell WiFi
Report a Pinout Error or Submit Tested Code Snippets
Found a pin mapping quirk or built a custom ESPHome YAML driver for Video Doorbell WiFi? Help us keep this matrix 100% accurate.