Is KY-005 IR Transmitter & Receiver Compatible with Home Assistant (ESPHome)?
Electrical Specifications
Always confirm pin assignments against the manufacturer datasheet before wiring.
Compatibility Overview
Infrared emitter and receiver pair for controlling HVAC air conditioners TVs and AV receivers via IR codes.
Wiring
Host connections for this device
Technical Specification Matrix
| Feature / Attribute | Specification / Status |
|---|---|
| Hardware Protocol | GPIO Digital / 3.3V |
| Bridge Required | NO |
| Border Router Needed | None |
| Hardware Capabilities & Peripherals | Universal Remote Code Climate IR Command Note: these entities come from the ESPHome configuration you flash — each one needs its matching component in that YAML before it appears. |
| Pairing Complexity | Plug-and-Play |
| Factory Reset Instruction | Hold FLASH button during boot. |
Wire, Flash, Adopt, Check
Wire it up
Follow the bus reference above. The host pins in the configuration are defaults — any free GPIO of the right kind will do, as long as the YAML names the pin you actually used.
Flash the configuration
Create a new device in the ESPHome dashboard (the Home Assistant add-on) and paste the configuration below into it, or save it as emb_esp8266_ir_esphome.yaml and run esphome run emb_esp8266_ir_esphome.yaml. The first flash goes over USB. If it is not detected, hold FLASH button during boot to put it in download mode. Every update after that is over the air.
Adopt it in Home Assistant
Settings → Devices & Services. A node on the same network shows up as a discovered ESPHome device within a minute of joining Wi-Fi; choose Configure and enter the API encryption key from your secrets.yaml. If discovery does not find it, add the ESPHome integration by hand with the node's IP address.
Check it works
The entities on this page appear under the device in Home Assistant and update at the configured interval. The ESPHome log (Logs in the dashboard, or esphome logs) reports the setup of each component and any bus scan results at boot.
ESPHome Configuration
Starting configuration for KY-005 IR Transmitter & Receiver on ESP8266. Untested on hardware — verify wiring and pins against your own board.
# ESPHome configuration for KY-005 IR Transmitter & Receiver
# Host: ESP8266. Pin numbers below are host-side defaults — any free
# GPIO will do, and you should change them to match your own wiring.
esphome:
name: emb_esp8266_ir_esphome
friendly_name: "KY-005 IR Transmitter & Receiver"
esp8266:
board: nodemcuv2
logger:
api:
encryption:
key: !secret api_encryption_key
ota:
- platform: esphome
password: !secret ota_password
wifi:
ssid: !secret wifi_ssid
password: !secret wifi_password
remote_receiver:
pin:
number: GPIO14
inverted: true
dump: all
remote_transmitter:
pin: GPIO12
carrier_duty_percent: 50%
Before you flash:
the !secret values come from your
secrets.yaml, and the GPIO numbers are host-side
defaults rather than properties of this part — change them to match how you actually wired it.
Report a Pinout Error or Submit Tested Code Snippets
Found a pin mapping quirk or built a custom ESPHome YAML driver for KY-005 IR Transmitter & Receiver? Submit a pull request or report corrections to our index.