Is 2-in-1 Switch Blue Series Compatible with Home Assistant (Zigbee2MQTT)?
This installation carries line voltage capable of causing severe electric shock, injury, or fire. Disconnect power at the breaker before wiring, verify with a non-contact voltage tester, and consult a qualified electrician if you are not confident working with mains circuits. Do not rely on this page as your only reference — confirm terminal assignments against the manufacturer's own documentation.
Electrical Specifications
Always confirm pin assignments against the manufacturer datasheet before wiring.
Compatibility Overview
High-performance Zigbee switch with advanced scene control and energy monitoring.
Wiring
Terminal assignments for this device
Terminal diagram not shown.
This device carries mains voltage, and its terminal markings vary by model and revision. Publishing a generic AC terminal diagram here would risk you wiring live conductors from a drawing that does not match the part in your hand — so we do not print one. Use the manufacturer's own installation sheet for terminal identification.
Technical Specification Matrix
| Feature / Attribute | Specification / Status |
|---|---|
| Hardware Protocol | Zigbee 3.0 |
| Bridge Required | NO |
| Border Router Needed | None (Zigbee Coordinator) |
| Hardware Capabilities & Peripherals | Light (Dimmer) Power (Watts) Energy (kWh) Button Scene Controller Discovered by the integration at pairing time. Which of these appear depends on your integration and its version. |
| Pairing Complexity | Advanced |
| Factory Reset Instruction | Hold top paddle and config button for 20 seconds until LED bar turns red and flashes. |
Step-by-Step Pairing Guide
Factory Reset Device
Hold top paddle and config button for 20 seconds until LED bar turns red and flashes.
Initialize Pairing Mode on Home Assistant (Zigbee2MQTT)
Open Home Assistant (Zigbee2MQTT) administration console, navigate to Integrations / Add Device, and start pairing scanner.
Confirm Entity Binding & State Verification
Verify that primary entities (Light (Dimmer), Power (Watts), Energy (kWh), Button Scene Controller) report live state changes inside Home Assistant (Zigbee2MQTT).
Report an Error or Share What You Found in Practice
Does the reset sequence not work, an entity not appear, or the compatibility verdict not match what you see with 2-in-1 Switch Blue Series? Report a correction to our index.