Is Eve Energy Smart Plug Compatible with Home Assistant (Matter / Thread)?
This installation carries line voltage capable of causing severe electric shock, injury, or fire. Disconnect power at the breaker before wiring, verify with a non-contact voltage tester, and consult a qualified electrician if you are not confident working with mains circuits. Do not rely on this page as your only reference — confirm terminal assignments against the manufacturer's own documentation.
Electrical Specifications
Always confirm pin assignments against the manufacturer datasheet before wiring.
Compatibility Overview
The Eve Energy Smart Plug is natively supported in Home Assistant via Matter over Thread with zero bridge required when an OpenThread Border Router is present.
Wiring
Terminal assignments for this device
Terminal diagram not shown.
This device carries mains voltage, and its terminal markings vary by model and revision. Publishing a generic AC terminal diagram here would risk you wiring live conductors from a drawing that does not match the part in your hand — so we do not print one. Use the manufacturer's own installation sheet for terminal identification.
Technical Specification Matrix
| Feature / Attribute | Specification / Status |
|---|---|
| Hardware Protocol | Matter over Thread |
| Bridge Required | NO |
| Border Router Needed | OpenThread Border Router (SkyConnect / HomePod) |
| Hardware Capabilities & Peripherals | Energy Meter (Watts) Total Consumption (kWh) Switch State Discovered by the integration at pairing time. Which of these appear depends on your integration and its version. |
| Pairing Complexity | Plug-and-Play |
| Factory Reset Instruction | Press and hold button on plug for 10 seconds until LED blinks red. |
Step-by-Step Pairing Guide
Factory Reset Device
Press and hold button on plug for 10 seconds until LED blinks red.
Initialize Pairing Mode on Home Assistant (Matter / Thread)
Open Home Assistant (Matter / Thread) administration console, navigate to Integrations / Add Device, and start pairing scanner.
Confirm Entity Binding & State Verification
Verify that primary entities (Energy Meter (Watts), Total Consumption (kWh), Switch State) report live state changes inside Home Assistant (Matter / Thread).
Report an Error or Share What You Found in Practice
Does the reset sequence not work, an entity not appear, or the compatibility verdict not match what you see with Eve Energy Smart Plug? Report a correction to our index.